If a volume change is detected, then (and only then) the message is sent to Loxone Miniserver (ie. The configured time is the amount of seconds how often or how soon after last command is the volume polled. If defined (as a number of seconds), enabled active polling for volume change compared to last known value. If you don't want to receive result (or to query the volume), you don't need to configure it. Loxone Miniserver IP address and UDP port (where to send the replies).Chromecast address (if you don't know it, try Discover tab in the plugin, it scans LAN for Chromecasts and lists their IPs).UDP port (where the plugin accepts UDP commands).Control volume (both absolute and relative).Plugin contains a server, which listens for UDP commands coming from Loxone Miniserver, performs desired actions on Chromecast and replies results back to Loxone via another UDP transmission. "Replies will be sent to:" section shows the configured Loxone target.Make sure the Chromecast is on the same network (same sub net). If not, check your configuration of Chromecast IP. Chromecast status should say "Connected".If not, check your configuration of UDP Port and restart LoxBerry, if still not OK.
FLIGHT RADAR 24 WIKI INSTALL
Follow the standard installation procedure to install the plugin, just link/upload the ZIP file in/to the LoxBerry Plugin Management.
Requires LoxBerry 1.2.2+ (briefly tested to work with 2.2)